Cooler Master MasterFan Pro 140 Air Flow RGB- 140mm High Air Flow RGB Case Fan, 3 In 1 with RGB LED Controller, Computer Cases CPU Coolers and Radiators

The Cooler Master 140mm fans fit my case perfectly. I had all 3 installed and cable managed in about 20 minutes. Each fan's wire leads are long enough to reach fan headers and the RGB controller from anywhere inside a normal Mid-Tower case. The excess wire would allow for use in much larger cases. However, I used my extra length to route the wires in hidden case trays and cable management ducts. The RGB controller is small and uses a magnetic mounting mechanism. The overall solution was painless to implement and the components work well together.The fans are very quiet. I replaced two 120mm OEM Phanteks fans with four of these 140mm Cooler Master fans and found it provided a dramatic reduction in noise.The LED lights provide a generous amount of illumination inside my case without being overpowering.The management software for the RGB controller has a nice visual user interface and provides flexibility in creating lighting effects.My only complaint is that Cooler Master does not fully support native integration with the RGB controller on my MSI motherboard. This would be a nice feature to have in the future for coordinating effects in both ecosystems.

My mobo (z370m pro4) doesn't support RGB but I wanted rgb fans. This was easy to install and get working. The backside is also magnetic which was SUPER COOL and made installing it a breeze. No double sided sticky tape needed. There is one extra rgb port on the controller that you can use to connect to any other device in your system. I had it connect to my p300 case leds and it worked fine. There are a lot of ways to customize your lights but unfortunately 'mirage mode' can only be turned on or off with no inbetween. Mirage mode also has a way to make port 2 different from the rest so if you have a special device that is different (aka 3 fans and 1 led strip) it would be best to set the led strip to port 2 on the controller. Software is easy to download and use. Fans are high quality and have rubber screw holes which eliminate rattling.

These are great case fans. They are quiet and move plenty of air to keep the system cool. I have 7 moving air through the case. If mounting with the fan facing the case use some small washers to offset the fan and keep it from making noise. Also be sure to not over torque the screw as the side housing will bend causing it to touch the fan either making noise or stopping the fan.

These fans are super quiet, in my opinion. Just be aware that with these type of RGB fans, the colors wash out because the LED is not bright enough to emit the light through the blades. I was aware of this issue before ordering them. You will never get true GREENS. Red works nicely, but it is not a deep red. I would not get these fans if you are going for a green setup, you will more than likely end up with a yellowish green. All in all, they do what they are supposed to do. If you want true, deep colors, go with ring RGB fans and not where the light goes through the blades. Works perfectly with Asus Aura.