Phanteks 1200RPM, Case/Radiator Fan, Frame/Blades - View 1

Phanteks 1200RPM, Case/Radiator Fan, Frame/Blades

4.6 (79 ratings)
N/A
View on Amazon

Key Features

  • The PH-F140SP, a high static pressure fan, have the ability to overcome the airflow restriction caused by high fin density.. Air flow - 82.1 CFM. Noise level - 19.0 decibels
  • The PH-F140SP has a larger base size with a magnetic brushless DC motor to avoid the effects of resonance and for rotational stability. To create better structural strength, Phanteks redesigned the back frame of the PH-F140SP.
  • With the noise reduction challenges in mind, we modified the component for lower actuator noise, PCBA for lower electromagnetic noise, brushless motor structure for lower operating noise and frame rib for lower wind and vibration noise.
  • The nine high static pressure MVB blades are precisely angled to generate a focused controlled airflow. The blades produces a downdraft vortex allowing for greater amount of air passage through and reduce airflow turbulence across the surface of the blades
  • Eight pre-installed rubber pads are now bigger and designed to reduce more vibration..Composed by MOSS and SSC systems, Phanteks' UFB bearings have an effective hub-tip ratio to achieve a state of equilibrium reducing air and vibration noise..SSC provides an increase in the bearing's lifespan and ensures that the fan's axis is consistently operational and quiet.

* The PC Builder is a participant of the Amazon Associates Program, through which we earn advertising commission on qualified sales by linking to the Amazon products.

Customer Reviews

Mark
I was looking for a replacement fan for my Shark. This is it. Quiet with good CFM. I run 9 fans in my desktop at very low speeds to keep the noise down. These are the quietest I have found while providing good airflow.
mav6932
Quiet, well built, moves lot of air, cost effective. Its a fan just buy and use it
Albert F.
Purchased two of these to replace the stock fans on my Enermax Ostrog GT case. They arrived in perfect condition and exactly as described (on both Amazon and Phanteks products page - do you research folks). To be clear, these are 140mm fans which can overcome high static pressure. They are good for radiator work and in areas such as front case fans that are typically installed in front of hard drives/hard drive cages.Both of them fit perfectly using the same screws that held the stock fans in place and do their jobs in providing fresh, cool air to my CPU/GPU. They completely own the stock Enermax fans that came with the case. I've seen a 5-9°C drop in CPU/GPU temps under load and it keeps my case cooler in general.As far as noise, I have noticed a bit of an increase over the old Enermax fans, but that is to be expected as they're pushing more air through the case. I don't notice them at all when gaming but the background noise they produce may bug those who seek silent PC builds.
cwwjr1681
Was a good fan. I however needed 4pin. This was 3. I bought it in a hurry at work. Was my own fault.